The National 2½" Gauge Association

Keeping the spirit of the past alive for tomorrow and looking to the future
The National 2½" Gauge Association is a not-for-profit organisation



Darjeeling Himalayan Railway Class B 0-4-0 Tank Locomotive

Notes on the Design

This has been scaled down from a general arrangement drawing of the 1913 version produced by the North British Locomotive Company and using many photos from the book by David Churchill. It is reasonably to scale but some parts may not be exactly correct. Some help was obtained by studying the 3½" version by Ray McMahon.

There were many changes applied to the locos over the years where parts from other locos were used to keep them running so most of the locos are now different from when originally built.

This is a complicated design so perhaps best suited to the experienced builder.

Dimensions are in mm but rounded to the nearest 0.5mm where possible.

Scale = 1.25" to the foot or 31.75mm to the foot

Overall length - 626mm

Overall width - 209mm

Height to top of chimney - 270mm

Cylinder Bore - 27mm

Stroke - 36mm

Wheel Diameter - 69mm

Weight - ?

The valve gear has been completely redesigned from scratch and gives excellent events in forward and reverse gears. Note that the expansion link has a large backset compared to the full size version which has none. The full size valve events must have been poor but it probably didn't matter for the intended use!

The inclination of the motion for the full size version is given as 1 in 12 or 4.76° but I have rounded this up to 5°

The frames of the full size loco require various curved angles which are probably best fabricated and silver soldered together.

The axle springing uses short coil springs hidden inside the dummy leaf springs as per the 3½" version and will require some experimentation to get the right sizes. The dummy springs could be made fully working which would probably be better.

The cylinders are complicated with various compound angles and a recessed port face so careful setting up and measuring will be needed. They can be machined from the solid or castings may be used if available.

Cylinder lubrication is by a mechanical lubricator mounted on the RH running board. Most of the original locos had Detroit style hydrostatic lubricators mounted in the cab but some did carry mechanical lubricators for a while.

The boiler on the 3½" version by Ray McMahon is a copy of that designed by Don Young for Mountaineer but the firebox is not the correct shape. It is made to look like the original by using an outer cleading shaped to match the original firebox outline. For this version the boiler has been completely redesigned to follow the firebox shape of the full size loco and has two radiant superheaters, two Gordon Smith 'Soft Pop' safety valves and a Gordon Smith design Poppet type regulator.

Water feeds are by twin axle pumps and a mechanical hand pump. An injector may be fitted if required by using one of the boiler clacks for the injector and the other for a combined hand pump/axle pump feed. One of the valves on the steam turret could be used for the steam supply.

Drawings Available

Drawings available soon

Castings Available

 

Construction Articles

Not available yet

This page was last updated on 16/06/2023